Photos

DANFOSS VLT AQUA DRIVE MANUAL EPUB

tation within this manual, Danfoss makes no warranty or This manual can be used with all VLT AQUA Low Harmonic Drive frequency converters with software . MAKING MODERN LIVING POSSIBLE. Operating Instructions. VLT. ®. AQUA Drive FC kW 2 Aug This publication contains information proprietary to Danfoss. By accepting and VLT® AQUA Drive High Power Instruction Manual MG

Author: Brakazahn Dikasa
Country: Guadeloupe
Language: English (Spanish)
Genre: Art
Published (Last): 18 May 2010
Pages: 343
PDF File Size: 1.85 Mb
ePub File Size: 13.52 Mb
ISBN: 690-3-91162-427-9
Downloads: 87970
Price: Free* [*Free Regsitration Required]
Uploader: Gosida

Enter motor nameplate data in the following parameter list. Terminal number 12, 13 Max.

VLT® AQUA Drive FC 202

Select All to LCP 4. AC Variable Speed Drives 0. Start with no power to the unit. Card Temp Slow-down Ctrl. No brake chopper included B: Installation and Operating Instructions. The display should show Press [Hand on] to start.

Sets the time format to be used in the LCP. The intermediate circuit voltage DC is higher than the overvoltage limit of the control system. Resolution of output frequency at Hz: Motor phase Aqux between the adjustable frequency drive and the motor is missing.

Exit Info mode by pressing either [Info], [Back], or [Cancel]. Reset the clock in – Date and Time.

  COCHICHANDO PARTITURA PDF

danfoss aqua drive fc manual

If the adjustable frequency drive is not in this mode, bit Out of frequency range in extended status word is active but there is no warning in the display. How to operate the adjustable frequency drive Status display I: Select a variable for display in line 1, right position.

Cable lengths and cross-sections: Setpoint 1 is used in closed-loop mode to enter a setpoint reference that is used by the adjustable frequency drive s PID controller. MCT 10 Set-up Software MCT 10 has been designed as an easy-to-use interactive tool for setting parameters in our adjustable frequency drives. Programmable relay outputs 2 Relay 01 Terminal danfoss vlt aqua drive manual breakmake Max.

Use par as another example: The USB connection is connected to protection ground on the adjustable frequency drive. Motor related parameters Step 3. If no 24 V backup supply is connected, the adjustable frequency drive trips after a given period of time, depending on the unit. However, in motors from 15 hp [11 kw] and up, the advantages are significant. This parameter cannot be adjusted while the motor is running. The module offers 4 PT inputs More information.

Danfoss vlt aqua drive manual regard to ambient temperature ratings, please see the Special Conditions.

Instruction Manual. VLT AQUA Drive FC 200

The speed of the motor can be seen in the LCP. There is a short-circuit in the motor or on the motor terminals.

  STK4142II PDF

Please ensure that the outer insulation of the motor cable is removed under the EMC clamp. Daker DK 1, 2, 3 kva. In the event of an alarm, the adjustable frequency drive will have tripped. Also use the [Status] key to toggle single or double readout mode.

Motor overload has tripped. The heatsink temperature is measured at 32 F [0 C]. Graphical display with Status aqus. Be social Take part. How amnual Use This Guide: Turn off the adjustable frequency drive and check if the danfoss vlt aqua drive manual shaft can be turned and if the motor size matches the adjustable frequency drive. The serial communication bus on the communication option card is not working. The function is initialized at 1.

Report value indicates source A no-flow condition has been detected in the system.

Back To Top